MASONRY SECTION DESIGN REINFORCED MASONRY SECTIONS DESIGN | M01
Summary Masonry Section is used to design reinforced masonry beams that span large openings in walls.
What makes this module special?
• 3D representation of the wall section • Detailed calculation output
Detailed Description Masonry Section verifies the resistance of a reinforced masonry beam at a critical section. It is assumed that the loads imposed on the beam cause uniaxial bending and shear.
The following wall types are supported: Single leaf
Collar jointed Grouted cavity
MASONRY SECTION DESIGN REINFORCED MASONRY SECTIONS DESIGN | M01
The design output shows the two failure modes: compression and tension.
Supported Design Codes
Design Codes
•
SABS 0164 - 1992
MASONRY WALL DESIGN OF LOAD BEARING MASONRY WALLS DESIGN | M02
Summary Masonry Wall is used to design various types of load bearing masonry walls.
What makes this module special?
• 3D representation of the wall section • Detailed calculation output
Detailed Description Masonry Wall determines the resistance of an unreinforced masonry wall, subjected to in-plane axial or out-of-plane loading causing bi-axial bending.
The module supports the following wall types: Single leaf
Collar jointed Grouted cavity
MASONRY WALL DESIGN OF LOAD BEARING MASONRY WALLS DESIGN | M02
The design output provides a tabular and diagrammatic summary of the design.
Supported Design Codes
Design Codes
• •
BS 5628 - 2005 SABS 0164 - 1992
MASONRY FREE WALL DESIGN OF MASONRY FREE-STANDING WALLS DESIGN | M03
Summary Masonry Free Wall can be used to verify the lateral load resistance of wall panels away from wall ends.
What makes this module special?
• 3D representation of the wall section • Detailed calculation output
Detailed Description Masonry Free Wall is used to evaluate masonry walls subject to out-of-plane loads. This module is a standalone program, i.e., it does not post-process results from any of the other analysis modules.
The following wall types are supported: Solid
Solid with piers on one side Solid with piers on both sides Staggered
Along with multiple load combinations of UDLs, line loads and point loads.
MASONRY FREE WALL DESIGN OF MASONRY FREE-STANDING WALLS DESIGN | M03
The design output provides a tabular and diagrammatic summary of the design.
Supported Design Codes
Design Codes
• •
BS 5628 - 2005 SABS 0164 - 1992
Page 1 Page 2 Page 3 Page 4 Page 5 Page 6 Page 7Powered by FlippingBook