MASONRY SECTION DESIGN REINFORCED MASONRY SECTIONS DESIGN | M01
Summary Masonry Section is used to design reinforced masonry beams that span large openings in walls.
What makes this module special?
• 3D representation of the wall section • Detailed calculation output
Detailed Description Masonry Section verifies the resistance of a reinforced masonry beam at a critical section. It is assumed that the loads imposed on the beam cause uniaxial bending and shear.
The following wall types are supported: Single leaf
Collar jointed Grouted cavity
MASONRY SECTION DESIGN REINFORCED MASONRY SECTIONS DESIGN | M01
The design output shows the two failure modes: compression and tension.
Supported Design Codes
Design Codes
•
SABS 0164 - 1992
Page 1 Page 2Powered by FlippingBook